
I made 8 of these little gate fold cards as customer thank yous. I adhered a little sample of our Basic Pearls on the inside flaps. To make the cards, you start with a piece of 3 x 6 card stock. From the long side score down the 3" length at 1-1/2" and 4-1/2" I used the new Stampin' Up! Simply Scored (see my side bar on the right) but you can use whatever method you have. I then decorated the outside flaps with the Brights Designer Series Papers (DSP). The scraps of the paper were punched out with the Bird Builder Punch and some scraps of white were punched with the scallop oval punch. I adhered the birds to the scallop oval and adhered the whole piece with a Stampin' Dimensional to the right flap only. A little pearl was added to the bird for the eyes and the wings are adhered to the bird with a Stampin' Dimensional also. I grabbed some ribbon I had handy and cut it to a length that I needed to make a bow after adhered it to the back of the card with a little strip of Snail adhesive and then wrapped it around the front and tied the bow. I should also note that the inside is also finished with a piece of DSP in the center panel with a scallop circle punch stamped with Thanks So Much. In addition to the 3 x 3 finished size, I made a couple a little shorter (2-1/2 x 3 finished size) because I had scraps of 2-1/2 x 6 inch card stock that I wanted to use up.
 |
Here are all 8
Note: Cards are 3x3 finished size with the exception
of the yellow and pink in the forefront. They are 2-1/2 x 3 finished size. |
 |
One of the cards open.
Thanks So Much stamped
and punches with scallop circle.
Basic pearl samples adhered to inside of flaps. |